Simple Ordering 
Expert Support 
Free Returns 
Water Flow Switch 2m Version2 for Heat Pumps: SW50/MS70/MPXC100/MPXC150 (1204020500043)
£45.00 Inc VAT
Please fill out the form below to enquire about availability:
"*" indicates required fields
Product Description
Aquark Water Flow Switch - 2m
The Aquark Water Flow Switch is an essential safety component for your heat pump. Its primary function is to detect water circulation within the system; if water flow is insufficient, this switch sends a signal to the control board to prevent the heat pump from running, thereby protecting the compressor and heat exchanger from overheating.
This unit is a direct replacement for the older version (10103030800006) and provides a robust, plug-and-play solution to restore your system’s safety monitoring.
Genuine Replacement Component (Replaces 10103030800006)
Installation Note:
Flow Direction: When installing the new switch, pay close attention to the flow direction arrow marked on the side of the switch body. It must be installed so that the water flows in the direction of the arrow. Installing it backward will result in a flow error code on your controller.
Seal Check: Always ensure the O-ring or thread tape (depending on the fitting type) is correctly applied to prevent leaks.
Testing: Once installed, check that the error code clears when the circulation pump is turned on.
Specifications:
Cable Length: 2m
Brand: Aquark
Compatible Models:
Heat Pumps:
SW50
SW70
MS70
MS90
MS110
MS210
MPXC100
MPXC150
MPN: 1204020500043
Customer Reviews
Write a review
Questions & Answers
Submit a question
You might also like
-
Heat Pump PCB/Control Board for Mr. Silence MS90 (2005130100050H20)
£184.00 Inc VATSKU: HT-PCBAK2
Water Flow Switch 2m Version2 for Heat Pumps: SW50/MS70/MPXC100/MPXC150 (1204020500043)
